Hand-held non-electric power tools. Safety requirements - Die grinders subscription-only

Hand-held non-electric power tools. Safety requirements - Die grinders subscription-only1 Scope This part of ISO 11148 specifies safety requirements for hand held non electric power tools fitted with collets (hereinafter die grinders) intended for grinding and surface finishing and chamfering using mounted points, burrs and files and small wire brushes and other accessories mounted on shanks. The die grinders can be powered by compressed air, hydraulic fluid or internal combustion engines and are intended to be used by one operator and

The test method for determination of seal strength and mode of specimen failure according to Annex C has been amended

PD IEC TS 63042-201 is the 201st part of a multi-series standard that covers design requirements for the UHV AC substations that enable the development of safe and secure substations with high transmission capacity and long transmission distance

Note 1: Generally

Description of the Standardised Facility Products

Diagrammatic representation of an example of local unit and speech communication

Who is BS 2782-9: Method 940B - Preparation of test specimens of amorphous thermoplastics for

Marking and documentation

This European Standard has been developed to measure PCDD/PCDF concentrations at about 0

As not all of the test methods previously used in the UK have been replaced by equivalent European methods

calculation is expected to be carried out

for transmission pipelines

the documents EN 50090-4-1 and EN 50090-4-2 provide sufficient information for the underlying mechanisms