BionX classic G1 Controller, without throttle lever, 01-2331

Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

BionX classic G1 Controller, without throttle lever, 01-2331This is the first BionX G1 classic controller. For CAN bus system (not for older I2C) There is no throttle lever on this one, only assist regen levels. The throttle module can not be used with this controller (01 4474). Is also not compatible with G2 dockings (01 3328) and needs a specific handle bar clip (not included) Comes pre programmed with firmware rev 64 Default pre programmed wheel diameter is 700c, no speed limit. Send us your specific wheel

(does not indicate charge DONE

BionX Tail light for Rear Rack batteries

Comes programmed with firmware rev

BCP3 protocol is not compatible with the original motor firmware or the G1/G2 controllers

BionX Light Set

Unplug the cell pack balancer plug

Only the controller is included

With DC ouput jack (for 6V lights)

When BionX introduced third generation controller (RC3 & DS3)

power connector

Does not comes with standard DB7 connector

but with classic power connector and silver covers