180 Degree Round Tube Die for 105 Standard Duty and Heavy Duty Tube and Pipe Bender (25.0 mm OD, 76.2 mm CLR) NPS 1-1/4

180 Degree Round Tube Die for 105 Standard Duty and Heavy Duty Tube and Pipe Bender (25.0 mm OD, 76.2 mm CLR) NPS 1-1/4Specs Outside Diameter of the Tubing (OD): 25. 0 mm Minimum Wall Thickness (DOM): 0. 065" (1. 7 mm) Minimum Wall Thickness (4130): 0. 065" (1. 7 mm) Minimum Wall Thickness (ERW): 0. 083" (2. 1 mm) Minimum Wall Thickness (Stainless): Contact for Details Minimum Wall Thickness (Aluminum): Contact for Details Minimum Wall Thickness (Other): Contact for Details Maximum Wall Thickness: 0. 134 (3. 4 mm) Centerline Radius: 3" (76. 2 mm) Maximum Degree of

Rotation & Angle" design interface

Most templates allow for center

Note: Requires mounting to a concrete floor

depending on the type

Designed for constant use

Flat Stock

Minimum Inside Radius: Approximately 70” (1778 mm)

1-1/2" (w) x 1/2" (leg) Channel Stock -Easyway

This roll set will bend the following sizes of material: 1-1/2" x 1-1/2" Square

360-degree vise rotation allows you to form a notch in any direction

16" x 17" Aluminum Table

10"-70" (Depending on the material)