2" Compression Point Compression Points

2" Compression Point Compression PointsThis particular point is the Largest point that we sell. It is actually 3" in diameter and will make a hole large enough to accommodate a 2" Sch 40 pipe with a coupling. The compression point is the first part to go through the ground and is attached to the Master shaft or quick shaft. It breaks rocks, splits roots and other debris as it makes its way through the ground and opens a hole larger than the shafts.

This tool pack comes with everything you will need to go under any 16 foot piece of pavement and install up to a 1 inch diameter pipe or conduit

6” centers

the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side

Eeither an electric or pneumatic jack hammer having a 1-1/8" hex shank may be used with the jack hammer adapter

As it advances It will chase the hole and push back out of the way any roots

1" Compression Point

splits roots and other debris as it makes its way through the ground and opens a hole larger than the shafts

QR Code with link to instructional video

it can be difficult to slide the pipe in by hand with the push point

The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap

4) The Bullet Mole shafts are extracted and the pipe or conduit is pulled into the hole behind them simultaneously

This connector is used to connect 1-1/4" poly pipe to the shafts before the shafts are extracted from the ground